DN Jetpack question

robotzo

Hunter
Hey guys, does anybody that has put together a DN jetpack know if this metal part that feeds through the rocket tube and connects to the fins is supposed to be able to move up and down? It only allows for the first ring to go in, but the channel looks like it intends for the entirety of this piece to be able to slide all the way down. I don't know if that's by design or if there was a little bit of shrinkage to the resin.

ycNpIk5.jpg
 
This thread is more than 2 months old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top