I started off with a similar sized trunk which was 146 L
View attachment 159450
IHowever it really wasn't big enough and didn't protect my kit very well as there wasn't any room to fit foam inside or my Blaster which I had to carry in a separate gun case
View attachment 159452
View attachment 159451
Which wasn't very convenient pulling the wheeled trunk whilst holding the gun case. So I bought one of these.
View attachment 159453
It's a Stanley Fatmax toolbox / Trunk im the US they are rebranded as Dewalt. It's 240L and fits all my kit in with ease . It's really sturdy and has a large pull out handle to pull it along.
I am going to add thick foam to the sides and bottom for extra protection for my kit.
The first modification was to make a gun and shin tool rack in the underside of the lid. This involved cutting out a piece of foamex/Sinatra that was slightly smaller than the Iid. I then placed the various pieces of equipment onto the board drew around them and then cut slots for the webbing to go through . I then mounted the board onto a larger piece of egg shell foam and glued it on. I then pushed the webbing through and attached self adhesive Velcro to each end. I then attached the board to the inside of the lid using self tapping screws and plastic tabs which hold the board in the lid securely. Here is where I am ATM. More to come.....
View attachment 159454
