Unknown Found Parts

Those quick connects that Drax found look like check valves also. If they were taken apart at the check valve end (lower portion) and mounted with the hex end at the base of the JP, it would look pretty close to what you have Hawk... By the way Hawk, your pieces look really good !!

I have seen the quick connects shown here and the top of them ( female side) are concave and don’t have the same internal appearance unfortunately
 
Hey hawk wherendid you get the quick connect you have on your JP?

The red thing is a magnetic drill bit holder I got off eBay. I cut the base off of it which is a pain since trying to hold the thing with out damaging it is tough .
 
This thread is more than 6 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top