Syper, thanks so much for finding these! I now have a set and was able to sculpt a fairly accurate digital model! Now we just need to figure out that piece that fell off!
Syper, thanks so much for finding these! I now have a set and was able to sculpt a fairly accurate digital model! Now we just need to figure out that piece that fell off!
Im pretty sure it is the MQ1 piece.. at least that i what the 3d prints all have on it. I will have to double check my pics cause I think there is one that shows it.
Syper, thanks so much for finding these! I now have a set and was able to sculpt a fairly accurate digital model! Now we just need to figure out that piece that fell off!
RafalFett , I should have known you would be YEARS ahead of me... even with the digital layout! I'll snag one of my endcaps for the MQ-1 this weekend and take a look, but it sure seems like you guys already nailed it.
I want to see about getting an aluminum plate made with screwholes for everything so placement is not an issue.
So just tried it... and considering that it aligns almost exactly (little bit of residue above the other two), especially horizontally, I think this is a safe bet.