So it begins...

WedgeOrgana66

New Hunter
first helmet has arrived and I cant wait to get started! Thinking I'll follow the wasted Fett instructions for the build. Any other recommendations on what i should do first?
 

Attachments

  • IMG_1684.JPG
    IMG_1684.JPG
    47.9 KB · Views: 160
first helmet has arrived and I cant wait to get started! Thinking I'll follow the wasted Fett instructions for the build. Any other recommendations on what i should do first?

I would run soap and warm water over it while rubbing it over with steal wool to get the mold release off.
 
wasted fett has some general step by steps for screwing on all the ear pieces and range finder. Just curios if theres a more in depth or detailed set of instructions out there that im not aware of?
 
This thread is more than 4 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top