Duran Lomax

Active Hunter
How exactly would I go about attaching the snaps to the back of the actual armor? Just straight out gluing it doesnt sound as if it would last.
I tried E-6000 industrial adhesive per TD-1536's online advise. It's still holding strong
after a year. Just glued the snap right to the armor. The other side is sewn to the vest.

Heres the site if you can't find it in a store......

The plastic, fiberglass or whatever your armor is will break before this stuff lets go.
I used JB Quick on my chest and knee armor (to hold on the strap). It works great and I have never had a problem.

This thread is more than 17 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.