Sholder emblems query

Ronin677

Well-Known Hunter
I was wondering if anyone could tell me what width the white patch on the sholder emblem is please. It has come to the point where i need to print one off and not sure how big it should be.

thanks ppl
 
Looking at one I got from VashDStampede, the width of the rectange is 4.5cm. The 'tusks' go a little outside the rectangle to 4.9cm.

The height of the rectangle is 8.9cm.

Hope that helps!
 
One thing to consider is you need to keep the emblem proportional to your shoulder bell. If your armor is smaller than the studio version you'll need to scale the emblem down to match your armor.

Alan
 
wizardofflight said:
One thing to consider is you need to keep the emblem proportional to your shoulder bell. If your armor is smaller than the studio version you'll need to scale the emblem down to match your armor.

Alan

cheers Alan

i think the dimensions given should be ok. Being 5'8" my armour is almost a large as the screen stuff
 
This thread is more than 18 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top