sentra stuff

Dillo2

Active Hunter
Ok ok ok ok ok I have chosen to make the dome part of my helmit out of sentra first of where can I buy it and how much is it. Also how on earth do you mold the stuff and if any of you have any tips for me I would much like to here them.
 
well, firsst of all I dont reccomend making the dome out of sintra. Secondly you can get it from US plastics, type it into google. Thirdly you dont mold it so much shapoe it and there are ample good articles in this forum on techniques if you use the search tab to find them.
 
The top of a batting helmet it tough, not terribly expensive, and wont fold at the edges like sintra will. The rest of the helmet can be done with sintra, but the dome is highly advised to not be done with it.
 
This thread is more than 18 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top