Blaster ROTJ EE-3 Blaster help

Lilac Fett

New Hunter
Hey fellow Hunters!

I'm thinking of doing a scratch build ROTJ EE-3 Blaster for my Boba Fett kit, but I'm a little lost on ONE piece. The heat sink ribs along the barrel. One tutorial I read said they used T-Tracks. My problem is, I can't seem to find the right ones. Most if not all are the "U" shaped tracks and not the "T" shaped ones I need.

If you know where I can find them or find suitable substitutes, please let me know
 
This thread is more than 4 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top