Cant remember if there was already a thread on this, but has anyone found a source for the correct size jack plugs and connectors for the right Gauntlet?
they always looked like the normal small headphone size plugs/jacks to me, ( 1/8th inch i believe) but i havent tried to confirm it yet. I was thinking about doing this set up to run wires though to the switches if i was to use them for sound clips, or smoke etc.
I'm still playing around with this a little bit, but this is what I came up with.
I'll probably 3D print a new housing for the jack-plug housing for a slightly cleaner fitment as there's a little binding where I didn't drill the bores in the resin housing quite straight enough
Got in the other type of female jack sockets and I gotta say I like these a lot more than the first type I tried
They’re much stronger and easy to adjust from the inside of the Gauntlet if need be, and the washer nuts are also .020” thinner, giving them a more low profile look like seen on the PP1 and ST suits above