RE: Sintra question

obi sean kenobi

Well-Known Hunter
Hi all,

I have a Fett cod piece that needs to be re-shaped a little - trouble is its already painted. How can I re-curve it to fir better?
Ive heard putting it in the oven for a minute or 2 - but I want some confirmation before i try it.

When I was doing my custom mandelore I had to reshape after it was painted. I just heated it up over the stove and reshaped it. It didn't do anything to the paint that I noticed. It should be fine as long as you don't let it cook. What kind of paint are you using? I used automotive paint which should stand up to the heat. Hope this helps.
This thread is more than 20 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.