Rangefinder/ears/servo/light kit

HawkFett

Hunter
So I'm at a standstill on my 3D printed helmet at the moment and am looking for some guidance and possibly a kit if available. I'm looking to buy a rangefinder/stalk, and ear that will fit my helmet that is functional for approval. I currently have all the parts mentioned but they weren't designed to fit a light kit or function with a servo. Anyone know someone that could do this job for me? I have taken the measurements but am wondering where I could get one printed that would accept JC's light kit and also be scaled to fit my helmet? Thanks for any input
 
This thread is more than 2 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top