range finder question

soilman

Active Hunter
I have the Murrow Son helmet and I am getting close to attaching the RF to the Stalk. how is the best way to do this. I am thinking about drilling several tiny holes and epoxying in small metal shafts and doing it that way. but if there is a easier way to do this let me know.

thanks
:thumbsup:
 
line up your RF with the post and drill 2 small holes, one on each side of the post. Then epoxy in a finishing nail into each hole you've drilled. You can also run a bead of glue along the top of the stalk. Hope this helps.


MS
 
This thread is more than 19 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top