New Cod Piece

[Dha Syntir]

I just received a new resin cod piece yesterday. As I was trimming and sanding it, I noticed what looked like a place where it looks like a hole "should be" on either side of the cod. I should drill those out as that's where the cod attaches to the lower back/butt plate, correct? Anyone off the top of their head, know what diameter drill bit I should use? Thanks.

 

[cal196]

I used velcro. I guess you could though since noone sees it anyway.

 

[MandoMan]

That's where Boba's cod and butt plate attach via the same studs used to attach the collar to the back plate. For the cod it's one on each side.

 

[Dha Syntir]

I assumed that was how they attached but wanted to make sure before I went drilling it only to find out later I screwed it up, again. What are the studs called? Greeblies? Or? And where can I get a set for my upper armor and the cod/kidney plates?

 

[psberetta]

What are the studs called? Greeblies? Or? And where can I get a set for my upper armor and the cod/kidney plates?

I have some sets for sale
http://www.thedentedhelmet.com/showthread.php?t=15348

Pm me for details

-Tim-

 

[Dha Syntir]

PM sent!

 

[MandoMan]

I have some sets for sale
http://www.thedentedhelmet.com/showthread.php?t=15348

Pm me for details

-Tim-

Yep, Tim makes awesome aluminum studs. You can't go wrong with them.

 

[psberetta]

PM sent!

PM replied to