Blaster Nemrod Holster 3D print files

djaidan

Hunter
hey everyone,

im no 3d modeller, but i had a go at this and im very happy with how it turned out, so i thought id share it among all you great people. and as you can see, it perfectly fits a 3d printed sidearm too.

there is a small issue down at the bottom of the file, but it prints fine, and its nothing a quick fill and sand wont fix.
if somoene is more proficient at 123d design, id be happy to share the original file if somoene wants to have a go and fix it.

hope you enjoy

Aidan

https://www.dropbox.com/s/xb0zc5m3zkl53ia/nemrod holster and logo.stl?dl=0

holster 2.pngholster top.jpgIMG_20170415_164417.jpgIMG_20170415_164442.jpgIMG_20170415_164505.jpgIMG_20170415_164516.jpgIMG_20170415_164525.jpgIMG_20170415_164543.jpg
 
That looks pretty good! I wonder how it would look printed in black rubber. I have a friend who can do that, I'll see what he says.
 
hi when you printed this did you have to change the scale.because when I put it in cura it said auto scale object 70% of original size?? did you get this message ?
thanks
 
This thread is more than 6 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top