Mold release agent

elfextra1

Active Hunter
I'm getting started on my fiberglass Clone armor. I have a mold ready, but I need a release agent. I'll pick up some Vasoline, because I her it works well. But would WD-40 also work?
 
believe it or not, i heard Cooking spray works well.. I havnt personally tried it, but a buck a can at the store.. I might try on something soon.
 
This thread is more than 17 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top