How to attach the rangefinder to the stalk.

use a dremel to cut a little groove(or a hole) that will fit the end of the stalk into and use epoxy glue. I use a 2 part epoxy and it has been very succesful.
Good luck!

This thread is more than 20 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.