Well-Known Hunter
Fiberglass Gaunts-Hose Clip 11/02

Just a quick post to show my gauntlet hose clip. I wish I could take credit for this idea, but it's how the Jango hoses were hooked in. I used to use some velcro to strap them to my arm, but it would always slide down as I wore it.

I hand sew the clip in with some nylon webbing. I placed it where the hoses would be when I streached out my arm as far as I could go. I didn't want the hoses to pull or strech out the suit when I moved my arm.

Then I duck taped the male end of the clip to the hoses.

Here's mine complete.

Here's the real Jango set up.
Very good idea! I've had such bad problems with my ESB hose coming out of my sleeve half way through an event. I think I'll try this idea. Thanks!
This thread is more than 19 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.