Help Mounting Shoulder Armor

jetpackman

Hunter
So I recently received a bobamaker flak vest with the grommets installed. However on the shoulders the flak vest has 3 grommets instead of two. Should I get another flak vest or should I utilize three posts on each shoulder plate. Help me lol
 
Here is the image
 

Attachments

  • Screenshot_20190601-220807_Messenger.jpg
    Screenshot_20190601-220807_Messenger.jpg
    519.6 KB · Views: 253
OK, your shoulder bell is to low. The red circle parts need to be mounted higher
IMG_20190602_084811.jpg


IMG_20190602_084505.jpg


The 3rd grommet will then be hidden under the shoulder bell
 
This thread is more than 4 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top