Help Attaching The Range To The Stalk?

Hey hey. I have a Bobamaker Rangefinder (hollow with a notch on the bottom) and an aluminum stalk I bought from a TDH member awhile back. The stalk doesn't have a piece on top to go into the notch in the rangefinder. Any ideas on how to get these two to be pals? Should I find teeny tiny screws and try that? Glue? Both?

- Jow!
 
Try to fill in the space by gluing in some sintra or better yet fill it with epoxy putty or resin. Then I would both glue & screw it to the post. That sucker will be rock solid.
 
This thread is more than 18 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top