Grappling Rocket Aluminum Fins

603Fett

Hunter
I purchased a pack that came without fins and after some searching I only found resin options. So instead I decided to make some by hand out of 1/8" thick by 1/2" wide aluminum. All you need is a vise, cutting wheel, and a metal file. Im thinking of using hot glue to set the fins into the rocket and with this the depth of the fin can easily be set. I suppose one could also easily drill a hole into each and attempt to make them moveable as well- I'm thinking with a small piece of spring rod through the hole and pushed into the slot. Anyhow please let me know what you think.
 

Attachments

  • F1r.jpg
    F1r.jpg
    1.4 MB · Views: 131
  • F2r.jpg
    F2r.jpg
    1.4 MB · Views: 131
  • F3r.jpg
    F3r.jpg
    1.1 MB · Views: 124
  • F4r.jpg
    F4r.jpg
    1.6 MB · Views: 146
  • F5r.jpg
    F5r.jpg
    1.2 MB · Views: 136
  • F6r.jpg
    F6r.jpg
    856.8 KB · Views: 127
This thread is more than 3 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top