That depends on the complexity of the crack and what the structural integrity of the workpiece is before the crack is fixed.
In most cases, Bondo works fine but sometimes the area needs structural reinforcement via. metal plates andsuch if it is really severe. If its really bad, it may be better to cut your losses and just get a new bucket.
This thread is more than 19 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.