Fibreglass Boba helmet W.I.P.

Reverend Scapegoat

Active Hunter
Here's the first stage of my fibreglass Fett helmet ( JudgeDweddz, IIRC... ).

I've roughly dremmelled out the triangles - Will finish them off later with a needle file as mine broke.

So so far, it's been primed, and has 2 coats of Tamiya gloss aluminium.
1 more of that, I thnk, then a clearcoat and I'll staart on the Olive Drab. ( Close enough! :) )

SecondSilverCoat.jpg
 
Last edited by a moderator:
This thread is more than 18 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top