Fiberglass Reinforcement


Well-Known Hunter
I'm starting my new gauntlets this week, and I was wondering if fiberglass reinforcement (on the inside) might be an option.

How is this process done? Expensive? What materials will I need?
I tried to do the same thing with my armor, which I ended up with the baskside kinda sticky, specially at the edges, leaving marks in my vest. I probably didn't mix the resin too good with the hardener or something.

I fixed the problem already. About the process, I strongly suggest to do that BEFORE you paint your armor, add velcro and/or assemble the gauntlets, the paint will cover any mistakes, and the gauntlets because it's just a hassle and difficult to do that while they're assembled. Just my 2 cents.

This thread is more than 20 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.