ESB Flamethrower

Ivan

New Hunter
I am looking for advise and or tips on how the tip of the flamethrower should look like. It appears to have a clear resin "baffle" like part. Anyone know where I can source and/or find a 3d print file?

Thank you.
 
I carefully lathed an acrylic rod. I didn't have a knurling tool. I think I based the whole build on what fett pride did. I think I still have a couple...
 

Attachments

  • FlameThrower.JPG
    FlameThrower.JPG
    721.4 KB · Views: 121
  • FlameThrowerTips.JPG
    FlameThrowerTips.JPG
    667.7 KB · Views: 112
Where are you located? If in the US I will send one to you for a few bucks, just to cover shipping. I can send more pics. I polished them.
 
This thread is more than 1 year old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top