Chest Display

could u shave it down a bit??? im sure it doesnt need to that compact (compact=thick) maybe rewire the tk409 one and and spread it out a lil....just a thought
 
MediaGuyPJ said:
Sadly its that its kind of thick, not soo much the over all size.

well, it's only as thick as the numeric leds + circuit board. i don't know that it could be made much thinner.

where are you putting it? i found that going in between the armor and vest didn't work well, but putting it inside the vest worked just fine. i cut an opening in the vest, and mounted the display inside. works great.
 
This thread is more than 18 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top