Custom Mandalorian C1RCA's Custome Mando in the works!

Thanks buddy , I can't wait to get out of work only 8 days to go and then I can finish the final assembly of the armor

C
 
Just an update things are starting to slow down , so we are starting our tear down should be home in 2 weeks and can start giving you guys updates on my armor once I get home

C
 
ok update from boba maker

1005136_478808575528306_636656042_n_zpsa66cb34b.jpg


deco is painted on this time

1010255_478838268858670_1373574141_n_zps5121f196.jpg


and jetpack ready for paint

993779_479747098767787_573092634_n_zps15736a86.jpg
 
either your Kneepads are missplaced or your shins are too short... Also the knees look a bit tiny o_O

I didnt know that bobamaker make custom jobs either.
 
so a lot of though i had been doing over this winter and i thought the best way to do my straps is not snaps but buckles and metal sliders will do nicely , ill have to do some digging around

C
 
ImageUploadedByTapatalk1393505917.104262.jpg

Here is v2 belt being doing by my leather maker he has done my chest plate and sith belt so I can trust him doing my mando belt :)
 
Love it. Anything that merges Mandos and westerns gets my seal of approval. Although how does that scope work, being on the outside of the holster?
 
This thread is more than 7 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top