BudaFett's ESB Fett WIP

Holster cleaned up and now on Boba! Funny, the sidearm was one of my first pieces to arrive for my build!

F8F0983C-0EC3-4968-A7FD-9B1A003E234B_zpsn1aakko0.jpg
 
Awesome build. I need to get working on a mannequin. You mentioned it was from eBay, do you remember which one specifically? Did you do anything else to stabilize the mannequin?
 
Awesome build. I need to get working on a mannequin. You mentioned it was from eBay, do you remember which one specifically? Did you do anything else to stabilize the mannequin?

I don't see the exact one I bought, it was 2 years ago, but this is similar. Fiberglass Male Headless Mannequin Dress Form Display MC PM1BW2 | eBay

I created a new base and it uses longer anchor screws to keep it in place. I also used some duck tape to stabilize the mannequin where it breaks down even though I've never had an issue but can't be too careful!
 
Got some updates:

Received pictures on September 16th of my helmet so these are a little old. I hope the helmet has seen some work since then, fingers crossed:

IMG_3843_zpsotfwbawg.jpg

IMG_3844_zpscbkjhxvm.jpg


Now at 1st I wanted to finished my RKD gauntlets myself but I am not that talented. Dom (Fett 4 Real) had some FP shells to go along with my FP greebies and offered a slot in his schedule to finish my gauntlets. This update was sent to me today:

IMG_4256_zpswuhjzles.jpg
 

Your message may be considered spam for the following reasons:

If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top