BobaFettSlave1
Active Hunter
well ill get strait to the point on this one. this is the MR helmet i recently bought. honestly the pinch is not that bad imo but im a stickler for stuff to atleast lookright to a cirtain point so i figured ide fix the damn pinch. the paintjob on this thing is amazing and there is no way i was going to cut the helmet to fix it so i asked what to do on the another board forum and i was told that the cut is completely unnecessary. Thanks for the help Lee. what i was told was to use a heat gun to heat the helmet up and make it flexible. had to do this VERY SLOWLY as to not ruin the paintjob. removing all but the top two screws on the virticle parts of both mandables (this keeps the mandables level like on the ESB filming helmet) and repositioning the existing visor (didnt want my nose to be pushing against a new thicker visor) so that the verry bottom screw holes were on the very edge of becoming visible then glueing the visor in place, i was able to do this.
the top & the bottom are now only 4mm in difference. this is not easily visible. i also removed alot of the green on the borden conecter to bring out the silver on it, also took some rust off the RF
what ya guys think?
PS:Anyone know how to adjust the speed of the RF lights? they are alittle fast to my liking
the top & the bottom are now only 4mm in difference. this is not easily visible. i also removed alot of the green on the borden conecter to bring out the silver on it, also took some rust off the RF
what ya guys think?
PS:Anyone know how to adjust the speed of the RF lights? they are alittle fast to my liking
Last edited by a moderator: