Anyone tried these?

I have one of these but I use it in my Kevlar and not in a SW helmet. It works ok but the water gets all over the place if you soak it to much. It might work in a SW helmet but you would have to try to get as much water out of it before you used the helmet.


-------------------EDIT----------------------------

I dont know how well it would work with a mic and fans inside your helmet.
 
Last edited by a moderator:
Ya water is constantly running out of the helmet. I had to ditch that idea. I did however se the ones you put into a feeezer that promised no condinsation.
 
This thread is more than 19 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top