Advice needed


Active Hunter
After an extensive search I have finally found a base gun to make original blaster carbines for my movie "The Mandalorian Wars". This means that I don't need to use dozens of EE-3's! However, I need help to cast the new carbine up.
As they're for a movie they need to be fairly robust but I really do not know how to go about casting them.
Also which would be better, Rubber or Resin? (I've done neither so any advice welcome)

Just the top of my head i would say rubber.. that's what most props are made out of anyway in the movies... either that or silicone..
This thread is more than 19 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.