a little help

ultimatefett

New Hunter
Im scratch maing my first boba fett helmet and Im wondering, what material is black and seethourgh for the visor? and should I make the whole entire T the visor, or should i just make the part my eyes are at the visor?
 
entire visor..


ive made a replacement for my bucket, from plexi-glas and paint sprayed the inner side, now it's like sunglasses.

I think theres something that can also be bend with a hot air gun or an oven, dark acryllic plates or whatever, but that may be hard to find, so I;d go for the plexi-glas sollution. It's cheap stuff, so you can also screw up a few times :p
 
This thread is more than 19 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top