Armor Question

pkbud74

Hunter

• Mar 17, 2016

• #1

The back armor that I have is concaved in the middle, almost like it's dented in. Will I be able to correct this by using a heat gun? Is there a better way? I can take a pic if needed. Thanks.

 

Darth Voorhees

Well-Known Hunter

Preferred Vendor

• Mar 17, 2016

• #2

Since its covered , if it didnt bother you when wearing it id leave it alone as to not riskany damage. BUT if it is warped in a way that makes it uncomfortable, then i think carefully heating it with a heat gun should work just fine

 

pkbud74

Hunter

• Mar 17, 2016

• #3

I was thinking that.....no one is going to see it and I don't think it's going to be bothersome, so I may just leave it as-is. Thanks Lou.

 

S

Sttryker

New Hunter

• Mar 18, 2016

• #4

Darth Voorhees said:

Since its covered , if it didnt bother you when wearing it id leave it alone as to not riskany damage. BUT if it is warped in a way that makes it uncomfortable, then i think carefully heating it with a heat gun should work just fine

Click to expand...

Unless its made of aluminum, lol

 

Darth Voorhees

Well-Known Hunter

Preferred Vendor

• Mar 18, 2016

• #5

Sttryker said:

Unless its made of aluminum, lol

Click to expand...

or that lol