vaccu forming links

[Darth Malevelus]

I found more than way to skin a fett, err, clone,... using a vaccuforming machine. and here are a couple of links

www.tk560.com

http://www.instructables.com/id/ELPFLBN6A9EYJ3I2F0/

Hope this helps

DM

 

[drcrash]

That instructable is for a tiny and lame vacuum former.

It's easy to make a much better one.

http://www.tk560.com/phpBB2/viewtopic.php?t=466
http://www.rcgroups.com/forums/showthread.php?t=621858
http://www.tk560.com/phpBB2/viewtopic.php?t=502

The vacuum forming forum on the tk560 discussion board is where it's at:

http://www.tk560.com/phpBB2/viewforum.php?f=1

BTW, it'd probably have been better to have bumped this earlier thread on the topic here on TDH:

http://www.thedentedhelmet.com/showthread.php?t=17010

Followups should probably go there so stuff doesn't end up scattered everywhere.

 

[tubachris85x]

That instructable is for a tiny and lame vacuum former.

It's easy to make a much better one.

http://www.tk560.com/phpBB2/viewtopic.php?t=466
http://www.rcgroups.com/forums/showthread.php?t=621858
http://www.tk560.com/phpBB2/viewtopic.php?t=502

The vacuum forming forum on the tk560 discussion board is where it's at:

http://www.tk560.com/phpBB2/viewforum.php?f=1

BTW, it'd probably have been better to have bumped this earlier thread on the topic here on TDH:

http://www.thedentedhelmet.com/showthread.php?t=17010

Followups should probably go there so stuff doesn't end up scattered everywhere.

Lots of very good and quality information right there, I can promis you that

-tubachris