T-Visor Template?



Does anyone have a t-visor template available online for those of us who use the welding masks?
I used my helmet as a templet.

1st. I started with the top of the "T". I looked at how tall and wide it needed to be.

2nd. I looked at how wide the botton of the "T" needs to be.

3rd. Cut out the "T".

Make sense?

T-Visor wrote:

For which bucket, dude? DP, Rubies, MSH2, MH or MS???

DP 97. I made my visor too small. I didnt keep any of the plastic I cut out form the DP.
This thread is more than 19 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.