Scratch Built Jet Pack ??

Jet Pack body - sintra & sheet styrene reinforced with liquid nails on the inside cornrers

Center rocket & tanks - pexiglass tubes

Thrusters - roller hockey balls & air fresheners

Tops of the tanks - neck of a bottle

Tank caps - cut a circle from a plastic oversized baseball & glued on top

Becon - 2 different sized nylon spacers.Used the cap from a sqeezer water bottle as the becon dome.

Rocket midsection - cut a section of a plastic oversized baseball bat and flipped it upside down

Rocket tip - styrofoam cone covered with paper & small funnel flipped upside down

Any questions pm me.
 
Last edited by a moderator:
Wait a minute boys, I'm from Texas so I'm as southern as it gets and we call it soda or coke. I know you're probably thinking I'm a conservative ahole, but I'm as Liberal as can be.
 
Last edited by a moderator:
This thread is more than 18 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top