Removing paint ?

FettTheHunter

Active Hunter
Hi :)

Is it absolutely neccessary to remove the paint job from a Don post helmet or could I just spray over it ?

A bit lazy I know but the helmet does'nt need to look perfect.

Many thanks :)

Randy
:jet pack
 
I didn't remove the paint on the first one I painted up & it worked out fine. Just give a good sanding with 180 grit to promote adhesion, wash the helmet & let it air dry, prime it & you're all set to go!
 
Last edited by a moderator:
This thread is more than 19 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top