reinforcing my bucket

Grizzly

Hunter
im using a jango rubies for my first helm, dunno why but it fits my melon pretty good, anywho i was looking for a few ideas for reinforcing the seam because i plan to bondo all the seams and sand em up to par. my thoughts are to glue the bajesus outta the inside and use some plastic strips along with that also what kind of foam would make good padding??? any and all help and suggestions are mucho grand'e appreciated. danka
 
If it's plastic, you could C.A. glue it and use the instant set. You could glue it and do some fiberglass on the inside. Probably easier just to ca glue it. ca is cyanoacrylate. Basically superglue. Hit up a train or hobby shop, make sure you get the accelerator.
 
This thread is more than 17 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top