RafalFett's Boba Fett 3D Projects

Just updated the first post with all the 3D models of the jetpack parts. Shapeways didn't allowed me to upload the jetpack body (mainly because this is not made to be 3D printed), so I added the STL file as an archived attachment.
 
Multiple updates/additions to the first post: the helmet greeble and electronics was updated with the helmet inner electronic board model, while the Supertrooper blaster aluminum plate model was updated with the corrected Glenross expansion screw. I also added to the end of the first post my interpretation of the ESB EE-3 Blaster Center Greeble.

Helmet Greeblies 21.jpg ST Blaster Parts 15.jpg Stock Center Greeble 01.jpg
 
The end of the first post was updated with the 3D models (these are printable models) of the Boba Fett helmets: the Supertrooper (clean), the Pre-Pro #1 (gash) and the other helmets (dented):

Helmets.jpg
 
The end of the first post was updated with the accurate Pre-Pro #1 collar buckle model:

PP1 Collar Buckle.jpg

Also the model was separated in 2 parts: the main body with the clip and the inner metal parts and bolts.
 
This thread is more than 4 months old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.

Similar threads

dogbertwrldrulr
dogb Boba Fett ROTJ Hero Build Thread
2 3
Replies
42
Views
511
dogbertwrldrulr
dogbertwrldrulr
Brail khan
boba fett jetpack stl help
Replies
3
Views
304
Brail khan
Brail khan
Bobamannen
Bobamannen's ROTJ build
Replies
12
Views
498
ShortFuse
ShortFuse
DrToothache
General DrToothache's ESB Boba Fett
2 3 4
Replies
79
Views
3,225
DrToothache
DrToothache
C
Boba Fett Costume Build
Replies
4
Views
617
SPY007
SPY007
Back
Top