Question about painting and installing rangefinder and servo

mattman1138

Hunter
Hello, I was wondering how everyone is installing the rangefinder and servo unit, before or after painting? Not sure what the best way to handle this is. Thanks!
 
Do any drilling or filing you need to do to accommodate the servo before painting of course. Then probably paint parts then final assemble. Test fit it all first though to see if you need to do anymore drilling/filing work.
 
Do any drilling or filing you need to do to accommodate the servo before painting of course. Then probably paint parts then final assemble. Test fit it all first though to see if you need to do anymore drilling/filing work.

Sounds like a good plan. Thanks for the response!
 
This thread is more than 4 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top