Pepakura Helmet Stand

Thread starter dung0beetle
Start date May 4, 2010

dung0beetle

Active Hunter

May 4, 2010

http://www.4shared.com/file/A0xkEzxu/helmetstand.html

Fill it with expanding foam if you are planning to use it as a permanent stand for a heavy helmet. I made it to hold helmets while fiberglassing so my helmets don't stick to the frikkin' table...again. Scale it to fit your helmet.

This thread is more than 15 years old.

Your message may be considered spam for the following reasons:

This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.

If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.

I am aware that replying to this thread may be considered spam, but I still want to make a reply.