Opinion on a EE-3 blaster

[Flykiller]

Up
No one with an opinion ? Good or bad ?
Thanks

 

[RafalFett]

At a glance it looks good, but the image is low-res and is hard to say if the parts are close to accurate or not.

 

[Flykiller]

At a glance it looks good, but the image is low-res and is hard to say if the parts are close to accurate or not.

Thanks

 

[Flykiller]

 

[Flykiller]

the image is hard to say if the parts are close to accurate or not.

Does this help ?

 

[BudaFett]

Doesn’t seem to be too awful. The LMK plugs aren't accurate and the grip is missing the grooves, it shouldn’t be flat.

 

[Flykiller]

Doesn’t seem to be too awful. The LMK plugs aren't accurate and the grip is missing the grooves, it shouldn’t be flat.

Thanks so much ! I'm going to work on this right now.

 

[Flykiller]

Is there another piece I should zoom on so you could tell me an advice ?

 

[Flykiller]

My friend has been working a lot to be acccurate.
Are these new files ok ?

Thank you again for help and advices !

 

[Flykiller]

No comment ?
Does it mean we are ready to print ?

 

[Gilmortar]

What does it look like with out the visible edge lines? It's hard to distingush with them along with the hard edges.

 

[Funkyred]

No comment ?
Does it mean we are ready to print ?

Your scope is missing its knobs

 

[Flykiller]

 

[Flykiller]

What does it look like with out the visible edge lines? It's hard to distingush with them along with the hard edges.

Is it better ?

 

[Flykiller]

Your scope is missing its knobs

Despite the missing knobs that obviously will be added, is it good ?

 

[Gilmortar]

the only thing i see, is that the trigger curvature is too flat. It needs to roll more forward and match the curve of the spine of the trigger guard. Sorry for the crappy MSPaint, but this:

 

[Flykiller]

Thanks
With the MS Paint, I understood very quicly what you meant !

 

[Flykiller]

Hi guys !
Thanks again all for you time !
Here is the last file my friend has been working on !
I'm waiting for your comments ;-)

Thank you for reading,

 

[Gilmortar]

Don’t forget the embedded relief lines of the track for the chamber release above the trigger.

 

[Gilmortar]

This part: