New Style Chest Display (Opinions Wanted)

Thread starter HotPockets
Start date Oct 28, 2019

HotPockets

Hunter

Oct 28, 2019

Hi Everyone,

Over the past 4 or 5 years I have been making screen accurate programmed Boba Fett Chest Displays. I was curious if there is community desire for a lower profile model made with surface mount electronics. This would allow you to have a much thinner version of the board, along with one that allows you to switch between the sequences from RotJ as well as ESB. It would cost a bit more to produce (about 25%). I was just checking if folks had interest before I invested in producing prototypes.

Thanks!

This thread is more than 4 years old.

Your message may be considered spam for the following reasons:

This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.

If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.

I am aware that replying to this thread may be considered spam, but I still want to make a reply.