My wooden jet pack parts

Reverend Scapegoat

Active Hunter
My wooden jetpack parts

A mate of mine lathed these up for me, and dropped them off tonight.

Thoughts please, people? :)
WoodenParts.jpg
 
These parts are probably going to end up on a rush-job foam-and-plastic pack for hallowe'en / Memorabilia.
But at least I HAVE them, and can remove them to put on something more accurate at a later date :)
 
Last edited by a moderator:
Dang that is Good! The "Sniffer" is enthralled by the scent of pine and Mohagany.
I wonder how much all this will weigh Scapegoat. The "Sniffer" must know!
 
Last edited by a moderator:
Those look great! I always wondered when someone would attempt this. I can't wait to see how they look painted up.
 
Last edited by a moderator:
wow! those look awesome!! :)
won;t you see wood nerves when painting?
 
Last edited by a moderator:
They look like Fir or Pine...if its sanded and primed right, they should be just fine!
 
Last edited by a moderator:
This thread is more than 18 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top