My scratchbuilt Vac u form Left gauntlet

I gotta ask - where did you get the rocket part? PM if necessary...

Nice work on the gauntlets! I'm actually building a vac-table right now, based on the design from Studio Creations.

Got me a 6hp Shop-Vac...
Yes it is vacuformed, even the flamethrower part is. Not pictured is the bottom part of the flamethrower which is vacuformed too. It makes it very light weight,which means it won't keep rotating on my arm.
This thread is more than 21 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.