My New Cod Design

Jodo Kast 2749

Active Hunter
I'm sure we've all noticed that the basic cod design as seen in the Mandalorian Blueprints is far too shallow. I finally got around to modding my own templates to create a sintra cod piece that isn't your typical Ebay offering. I used a double layer of sintra for the front detail and snaded it on an angle to try to get close to that "vac'd" look.

I think I got it down pretty well. Feedback as always is much appreciated.

J.

IM000306.JPG
 
I think you are on the right track. Have you seen the cod i mad resently? It is made simaler to yours except i used bondo on the bottom curve to give it a 3D look.

<img src=http://200.72.163.179/cdref/tdh/Armor/cod1.jpg>
<img src=http://200.72.163.179/cdref/tdh/Armor/cod2.jpg>
<img src=http://200.72.163.179/cdref/tdh/Armor/cod12.jpg>
 

phantom viper wrote:

Have you seen the cod i mad resently?

Are you kidding? Your stuff is my inspiration for all things sintra.

I tried to get some horizontal curves in there as well so it would be cuplike but sintra would need a lot more heat than I was using to stretch like that. It's like folding paper; lots you can do but some shapes that just won't work.
 
This thread is more than 19 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top