My New Cod Design

[Jodo Kast 2749]

I'm sure we've all noticed that the basic cod design as seen in the Mandalorian Blueprints is far too shallow. I finally got around to modding my own templates to create a sintra cod piece that isn't your typical Ebay offering. I used a double layer of sintra for the front detail and snaded it on an angle to try to get close to that "vac'd" look.

I think I got it down pretty well. Feedback as always is much appreciated.

J.

 

[phantom viper]

I think you are on the right track. Have you seen the cod i mad resently? It is made simaler to yours except i used bondo on the bottom curve to give it a 3D look.

<img src=http://200.72.163.179/cdref/tdh/Armor/cod1.jpg>
<img src=http://200.72.163.179/cdref/tdh/Armor/cod2.jpg>
<img src=http://200.72.163.179/cdref/tdh/Armor/cod12.jpg>

 

[T Visor]

A good codpiece should be curved, otherwise people could think that Fett has a small one.

 

[TBone]

...and if its too flat it is uncomfortable...

 

[Jodo Kast 2749]

phantom viper wrote:
Have you seen the cod i mad resently?

Are you kidding? Your stuff is my inspiration for all things sintra.

I tried to get some horizontal curves in there as well so it would be cuplike but sintra would need a lot more heat than I was using to stretch like that. It's like folding paper; lots you can do but some shapes that just won't work.

 

[FANGS]

Oh sure Jodo_Kast....NOW you revamp your cod.......

 

[Jodo Kast 2749]

You know I only sell you my cast offs baby!

 

[FANGS]

So I noticed....geesh!