my homemade blaster -rebuilt.

Yroc Yar

Active Hunter
i just put the finishing touches on it . found new stock parts . i used comtech chips and " butt hinges " from the boat section at wal-mart .and i carved the stock out of a 2x4 with my dremel .for the gun parts i used a daisy pellet gun and a sink pipe .and it's sturdy now to . it used to fall apart all the time at cons, but i don't see that happening now .

This thread is more than 19 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.