My first build

Thread starter RatFink
Start date May 1, 2022

RatFink

New Hunter

May 1, 2022

#1

Hey you guy’s some serious work going on here! I just wanted to post my first go at a helmet. I 3d printed it in 4 parts and grafted them together, then LOTS of sanding! The helmet was drawn by Christopher Kouvelis on thingyverse.
I designed the t visor in illustrator and laser cut it and then thermo formed it. I then used the amazing stencils by RafalFett. Not quite right but got my head around it now. I opened the stencils in illustrator and laser cut them on vinyl transfer film. This works quite well so you don’t pull any paint off. I re drew the range finder in solidworks and 3d printed it and made a circuit with a tilt switch I found on the internet.
My next build will hopefully my own design.

This thread is more than 1 year old.

Your message may be considered spam for the following reasons:

This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.

If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.

I am aware that replying to this thread may be considered spam, but I still want to make a reply.