Key slot bubbles

[Mjolner]

I recently got a helmet with resin bubbles (blobs) in the key slot by the mq1 board. Any guidance on how to remove these without damaging the bucket?
Thanks!

 

[Fett 4 Real]

Carefully...or cut them out and install an MQ1 casting....

 

[dolioshmolio]

i used a dremel rotary tool with a small engraving cutter bit.. its got a little ball on the end .. just find one that fits between the slots.. are you any good at the game operation?

 

[Mjolner]

Ha! I suppose we'll find out!
That's no different than a regular dremel cutting tool with a different but on it, yes?

 

[dolioshmolio]

correct ... just a regular dremel ... and good luck.. just remember if it gets bad you can always do what Fett4Real suggested and cut them out and put in a MQ1 casting..